Plan 65643BS: 3-Bed Contemporary Home Plan with Two-story Great Room and a Covered Lanai

Plan 65643BS

3-Bed Contemporary Home Plan with Two-story Great Room and a Covered Lanai

Heated S.F.

3,087

Beds

Baths

4.5

Stories

Cars

Floor Plan

Main Level

2nd Floor

Plan Details

A simple palette of materials creates the fresh exterior of this contemporary house plan, while inside, an oversized sliding door consumes the rear wall and marries the great room with the outdoor living area.
Enjoy cooking in this gourmet kitchen, which features an island, large range, and walk-in pantry tucked beneath the stairwell.
A quiet study neighbors a full bath just off the foyer, and the 2-car garage enters into a mudroom with a coat closet.
Retreat to the master bedroom for peace and quiet, and discover two walk-in closets and a 5-fixture bathroom. French doors open to the outside.
Upstairs, a loft overlooks the great room below and includes a forward-facing balcony. Bedroom suites 2 and 3 sit on either side of the loft.
BUILDING RESTRICTION: Restrictions may apply if building in Lee and Collier Counties, Florida as well as Sarasota, Florida. Please contact us with your site address to confirm.

What's Included

Elevations: - Drawn at 1/8″ to 1/4″ = 1’0″ Scale and Includes:

Material Labels
Floor-To-Floor Heights
Roof Slope Indicators

Floor Plans: - Drawn at 1/8″ to 1/4″ = 1’0″ Scale and Includes:

Door and Window Sizes
Completely Dimensioned Floor Plan
Room Labels and Interior Room Sizes

Electrical Layouts:

Building Section Markers
All Electrical Outlets, Fixtures and Switching

Foundation or Slab Plan: - Drawn at 1/8″ to 1/4″ = 1’0″ Scale and Includes:

Floor and Deck Joist Sizes, Spacing and Direction
Electrical Locations

Roof Design Plan: - Drawn to 1/8″ to 1/4″ = 1’0″ Scale and Includes:

All Beam and Header Heights and Locations
All Hips, Gables, Ridges and Valley
Building Section Markers

Building Sections: - Drawn to 1/8″ to 1/4″ = 1’0″ Scale and Includes:

Floor-To-Floor Heights
Non-Typical Plate Heights Indicated

Typical Wall Sections: - Drawn at 1/8″ to 1/2″ = 1’0″ Scale and Includes:

All Labels Indicating Wall Construction
Foundation Wall Thickness
Insulation Type and Thickness

Miscellaneous Notes and Details:

Miscellaneous General Notes
Stairway Details (if applicable)

What's Not Included

Architectural or Engineering Stamp - handled locally if required
Site Plan - handled locally when required
Mechanical Drawings (location of heating and air equipment and duct work) - your subcontractors handle this
Plumbing Drawings (drawings showing the actual plumbing pipe sizes and locations) - your subcontractors handle this
Energy calculations - handled locally when required

IMPORTANT NOTE: Structural drawings, as well as heating and plumbing details, will not be included in your plan sets due to a variety of factors which include local codes, installation methods, personal preference, etc. Your building professional (contractor/builder/supplier) can, without difficulty, supply these details and specifications on your behalf.